- | P a g e
pg. 1
2025 VA HIC LICENSE EXAM LATEST TEST BANK|
COMPLETE 300+ REAL EXAM QUESTIONS AND
CORRECT DETAILED ANSWERS (VERIFI ED
ANSWERS) ALREADY GRADED A+| BRAND NEW!!
What is the minimum diameter of a circular turnaround area in a new building? - ANSWER - 60" ANSI Accessible and Usable Buildings and Facilities, 2017 Page 10
Doorways shall have a clear opening width of 32 inches minimum.Projections into the clear opening width between 34 inches and 80
inches above the floor shall not exceed: - ANSWER - 4 inches
ANSI Accessible and Usable Buildings and Facilities, 2017 Page 25
What is the first step to placing a bifold door? - ANSWER - Install the top track first Carpentry and Building Construction - Page 616
Glulams are sometimes manufactured with a slight upward curve known as ____? - ANSWER - Camber Carpentry and Building Construction - Page 361
- / 4
- | P a g e
pg. 2 When using a splash block to direct water from a down spout, how long should it be to carry away water from the foundation? - ANSWER - 3' Carpentry and Building Construction - Page 653
How many bundles are usually in a square of 3-tab shingles? -
ANSWER - 3
Carpentry and Building Construction - Page 637
What would be mixed into a concrete mixture to control the wear resistance and stability of concrete? - ANSWER - Water Carpentry and Building Construction - Page 223
What is the typical height of a regular base kitchen cabinet? - ANSWER
- 34-1/2"
Carpentry and Building Construction - Page 784
A roll roofing strip should have at least how many inches overlapping at the eave? - ANSWER - 1/4" Carpentry and Building Construction - Page 629
Of the species commonly used in house construction, the heartwood of bald cypress, redwood, and various cedars is highest in _______ resistance. - ANSWER - Decay Carpentry and Building Construction - Page 329
- / 4
- | P a g e
pg. 3 Before concrete is placed, what is commonly used to secure the sides of foundation wall forms to prevent spreading? - ANSWER - Snap ties Carpentry and Building Construction - Page 265
On a blueprint, what do lines that end with arrows represent? - ANSWER - Dimension lines Carpentry and Building Construction - Page 45
Which of the following is not a required material when mixing a concrete batch? - ANSWER - Calcium chloride Carpentry and Building Construction - Page 218
What should be placed with every second course when you are building a stack bond pattern block wall? - ANSWER - Joint reinforcement Carpentry and Building Construction - Page 276-277
What do air-entraining admixtures improve within a concrete mixture? - ANSWER - Workability Carpentry and Building Construction - Page 221
What type of mortar is recommended for masonry below grade? -
ANSWER - M
Carpentry and Building Construction - Page 694
- / 4
- | P a g e
pg. 4 House wraps do which of the following? - ANSWER - Allow water vapor to pass through Carpentry and Building Construction - Page 661
Which type of mortar has average strength for most general masonry work above grade? - ANSWER - Type N Carpentry and Building Construction - Page 278
Simple slope or benched slope excavations deeper than ___' must be designed by a registered engineer. - ANSWER - 20 Carpentry and Building Construction - Page 82
What is the term for the board that is nailed to the ends of rafter tails? - ANSWER - Fascia Carpentry and Building Construction - Page 552
Stair headroom is measured from the ceiling directly above which point?
- ANSWER - Edge of nosing
Carpentry and Building Construction - Page 730
Anchor bolts should be spaced no more than __' apart and no more than __" from the ends of any plate section or wall corner. Each bolt must extend at least __" into the concrete. - ANSWER - 6, 12, 7 Carpentry and Building Construction - Pages 268-269
- / 4