Advance Rigger Test Questions And Correct Answers

Study Guides Aug 17, 2025
Loading...

Loading document viewer...

Page 0 of 0

Document Text

Advance Rigger Test – Questions And Correct Answers What is meant by the term "two blocking"?

  • Placing blocks under the outrigger beams.
  • The load block contacts the boom point sheaves.
  • Stacking loads on top of one another.
  • The load strikes the boom while swinging. Correct Ans - b. The
  • load block contacts the boom point sheaves.Lifting 20,000 lbs with a 2-leg bridle sling at a 30° horizontal sling angle, what is the force applied to each leg?

  • 10,000 pounds
  • 20,000 pounds
  • 30,000 pounds
  • 40,000 pounds Correct Ans - b. 20,000 pounds
  • In multiple crane lifts using an equalizer beam, the weight of the beam

should be considered:

  • Part of the crane boom
  • Part of the load weight
  • Part of the crane weight
  • A non-factor Correct Ans - b. Part of the load weight
  • What is required if there is a deviation from the lift plan?

  • The supervisor's permission
  • The rigger's permission
  • A new lift plan
  • Mark ups on the existing lift plan Correct Ans - c. A new lift plan
  • On level ground using skids and rollers, what percent of the weight of the load should yield the required line pull as a general rule of thumb?

  • 2%
  • 5%
  • 10%
  • 20% Correct Ans - b. 5%
  • All of the following are results of unbalanced reeving of the hook block

EXCEPT:

  • Wear on the sheaves 1 / 2
  • Torque on the boom
  • Wear on the hook
  • Wear on the wire rope Correct Ans - c. Wear on the hook

Before a spreader bar or beams can be used they MUST have been:

  • Repainted
  • Used before
  • Tested and approved
  • Upgraded from the previous job Correct Ans - c. Tested and
  • approved

When materials are being hoisted to an upper level, a tag line is used to:

  • Help raise the load
  • Help control the load
  • Stop the process
  • Stop material from falling Correct Ans - b. Help control the load
  • Two cranes are lifting 100 tons. If crane A has 40% of the load, how much weight will crane B have on its hook?

  • 60,000 lbs
  • 80,000 lbs
  • 120,000 lbs
  • 240,000 lbs Correct Ans - a. 60,000 lbs
  • To CONFIRM the rated capacity of a specific sling, consult the

manufacturer's:

  • Sling chart
  • Website
  • Sling tag
  • Catalog Correct Ans - c. Sling tag
  • OSHA regulations require hook replacement if the opening exceeds what percentage of its original throat opening?

  • 10%
  • 15%
  • 18%
  • 20% Correct Ans - b. 15%
  • / 2

Download Document

Buy This Document

$30.00 One-time purchase
Buy Now
  • Full access to this document
  • Download anytime
  • No expiration

Document Information

Category: Study Guides
Added: Aug 17, 2025
Description:

Advance Rigger Test – Questions And Correct Answers What is meant by the term "two blocking"? a. Placing blocks under the outrigger beams. b. The load block contacts the boom point sheaves. c. St...

Get this document $30.00