Automotive Service Fundamentals Final Exam Study Guide (all correctly answered) ASE Education Foundation correct answers What organization accredits automotive programs?ASE correct answers What organization certifies automotive technicians?
franchises correct answers Carquest, NAPA, and Jiffy Lube are examples of:
star pattern correct answers When torquing lug nuts on a vehicle, which pattern should one use?synthetic oil correct answers Which engine oil has the best lubricating properties?red correct answers Which color is the primary brake warning light on the dash of cars and trucks?bulb correct answers Which part is most likely the problem if a light does not come on during an instrument panel bulb check?a only correct answers Technician A says mopping up a spill is a good safety practice to use in the shop. Technician B says leaving one's workstation a mess is a good safety practice to use in the shop. Who is right?green and white correct answers Using the OSHA system of safety colors, what color strip would indicate the location of the shop eye wash station?look for a map posted by the door correct answers In case of a fire, where would a student find out where to go?pull, aim, squeeze, sweep correct answers When using a fire extinguisher, what do the letters PASS stand for?caution correct answers What do the yellow lines on an automotive shop floor indicate?running and the shop is not vented. correct answers Carbon monoxide poses a danger if a vehicle
is:
Goggles correct answers Which type of eye protection should be worn while working with chemicals?SDS (safety data sheet) correct answers A chemical has spilled on a student in the shop. What is the name of the document that outlines the first aid action needed?battery correct answers When one is working on an HID (high intensity discharge) lighting system, which should be disconnected? 1 / 2
PPE correct answers Proper shoes, safety glasses, hearing protection, and a mask are known as: 15 minutes correct answers How long should eyes be flushed after a chemical has been splashed into them?American National Standards Institute correct answers What does the term ANSI stand for?Oxygen correct answers Which is an element of the fire triangle?b only correct answers Technician A says to place automotive lift arms close together would be more stable. Technician B says to lower the vehicle onto the lift stops before beginning to work on it. Who is right?Use a larger drive size. correct answers When a bolt or nut is too tight to loosen with the socket currently being used, which is the safest solution?using a parts washer correct answers Which activity requires the use of nitrile gloves?safety glasses and closed-toe shoes correct answers Which two safety items should always be worn in an automotive shop?A only correct answers Technician A says an ABS will pulsate the brakes during hard stops.Technician B says ABS brakes are found only on vehicles that have been imported. Who is right?disarm the system or disconnect negative battery terminal correct answers Before servicing the supplemental restraint system (SRS, airbags), what should a technician do as a safety precaution?disarm the system or disconnect negative battery terminal wheel bearing grease correct answers Which is the correct lubricant for the front axle on a rear- wheel-drive car? wheel bearing grease Neither A nor B (but...you can sub DOT 4 for DOT 3 but NOT 3 for 4, DOT 5 is synthetic) correct answers Technician A says it is acceptable to use brake cleaner to clean throttle bodies.Technician B says it is acceptable to mix DOT 5 brake fluid with DOT 3 brake fluid. Who is right?Oil them. correct answers What should be done to air tools daily to keep them in good working condition?outside micrometer correct answers What tool would be used to measure the thickness of a solid metal rod?
- point correct answers Which type of socket will best hold a nut and/or bolt?
- / 2