FSVO state test with complete solutions.The purpose of using a spotter is to - Answer the driver by observing cross traffic the as the area in the blind spot horizontal and vertical openings, the operator must know: To effectively judge the ability of a vehicle to pass through areas of restricted - Answer vehicle dimensions.Which driving skill would not require using a spotter? - Answer Diminishing clearance The distance a vehicle travels from the point where you begin recognizing the hazard until the apparatus comes to a complete stop is called the: - Answer total stopping distance.The confined space turnaround maneuver allows an operator to turn the apparatus degrees - Answer 180 Improper tire pressures may cause - Answer poor handling One method of performing an apparatus/pretrip inspection is the - Answer walk- around method.Before shutdown the apparatus engine temperature should be allowed to stabilize by idling it for minutes. - Answer 3 to 5 Checking for voltage, electrolyte level, and corrosion are all steps in inspecting: - Answer the battery.While traveling in the center lane of a multiple-lane highway on an emergency call, the vehicle in front of you stops. You should: - Answer brake to reduce speed and pass on the left side of the vehicle.The vacuum test requires a reading at the end of 5 minutes with no more than inches of vacuum being lost. - Answer 10
When responding to emergencies, the use of warning devices: - Answer does not
allow the driver to disregard other drivers.When approaching unguarded railroad crossings, the driver shall: - Answer come to a complete stop.Level I staging may be: - Answer used in the initial response to a fire or other incident involving more than one responding company.Many accidents involving apparatus are caused by the operator - Answer misunderstanding the capabilities of the apparatus.At a working fire, which apparatus has the highest priority for position? - Answer Aerial apparatus
- / 1