IFSTA 7 question and answers 2023 Which product of combustion acts as a chemical asphyxiant by excluding oxygen from the blood, leading to hypoxia of the brain and tissues?
- Carbon dioxide (CO2)
- Carbon monoxide (CO)
- Aerosolized fuel particles
- Hydrogen cyanide (HCN) - Correct Answer B
Combustion can occur within a range of concentration of fuel vapor and air; this range is
referred to as the:
- vapor pressure range.
- surface to mass range.
- flammable (explosive) range.
- oxidation (combustion) range. - Correct Answer C
- Whether the fire is fuel-limited or ventilation-limited
- Whether the fuel is cellulose-based or petroleum-based
- Ratio of square footage to ceiling height of the compartment
- Ambient temperature and wind speed outside the compartment - Correct Answer A
Which statement describes the factor that MOST influences compartment fire development?
An extinguishing agent, such as dry chemical or Halon-replacement agent, terminates
the combustion reaction by:
- cutting off the oxygen supply to the fuel.
- interfering with the chemical chain reaction.
- cooling the fuel below the ignition temperature.
- reacting with the fuel to create a fire-resistant layer. - Correct Answer B
- flaming
- nonflaming
- oxygen-enriched
- oxygen-deficient - Correct Answer C
- The SCBA was manufactured within the past five to ten years.
- A rapid intervention crew (RIC) is rescuing a trapped or incapacitated firefighter.
- The firefighter filling the empty cylinder is wearing full structural personal protective
- A firefighter with a higher rank than the firefighter wearing the SCBA cylinder is
Materials that burn at normal oxygen levels will burn more intensely in _____ atmospheres.
Which situation would likely be granted an exception to the rule that prohibits filling an unshielded air cylinder while a firefighter is wearing the SCBA?
equipment.
available to perform the refill. - Correct Answer B 1 / 2
What is a general safety precaution to take when refilling an SCBA cylinder?
- Wear full structural fire fighting PPE.
- Fill the cylinder as quickly as possible.
- Perform a hydrostatic test on the cylinder.
- Check the hydrostatic test date of the cylinder. - Correct Answer D
- Firefighter's name
- Department name
- Cleaning precautions
- Wearing instructions - Correct Answer C
- Stationary fill system
- Auto-cascade fill system
- High-rise specific cascade system
- Firefighter Breathing Air Replenishment System - Correct Answer D
Which piece of information must be included on the permanent compliance label inside each piece of PPE?
Which type of breathing air source would be found inside a high-rise building?
Annual SCBA inspections and maintenance should be performed by:
- a company officer.
- all available firefighters.
- specially trained, factory-qualified technicians.
- the highest-ranking fire department personnel. - Correct Answer C
After each use, the SCBA facepiece should be:
- cleaned, dried, and placed out of service.
- washed with warm water and a mild disinfectant.
- sanitized using a machine built specifically for facepieces.
- sent to the manufacturer for a commercial-grade cleaning. - Correct Answer B
When donning an unmounted SCBA, the SCBA unit should be:
- stored in an outside compartment of the apparatus.
- placed on the ground with all of the straps extended.
- stored in a specialized compartment inside the apparatus.
- placed behind the firefighter with all of the straps tightened. - Correct Answer B
Immediately prior to donning SCBA, firefighters should:
- record inspections in the SCBA log.
- perform a hydrostatic test on the cylinder.
- check to make sure that the bypass valve is disabled.
- check the cylinder gauge to make sure the cylinder is full. - Correct Answer D
All PPE designed for structural fire fighting must meet the requirements of:
A) NFPA 1002.
- NFPA 1006.
- / 2