- | P a g e
MICHIGAN STATE BRAKE CERTIFICATION TEST 2025
NEWEST EXAM CURRENTLY TESTING COMPLETE
EXAM QUESTIONS WITH DETAILED VERIFIED
ANSWERS (100% CORRECT ANSWERS) /ALREADY
GRADED A+/ BRAND NEW!!!
Most 1995 & newer vehicles use which of the following types of wheels bearings on non-drive wheel? - Answer- Sealed non-serviceable
to test a vacuum power brake booster in the vehicle, you should pump the brake pedal at least 4 times, hold the brake pedal depressed, and start the engine. the brake
pedal should: - Answer-drop slightly and remain firm
You are installing a set of brake shoe linings that are not
the same length. Traditionally, the primary shoe lining is: -
Answer-Smaller and goes towards the front of the car.
A cracked or torn vacuum diaphragm in a brake power
booster would most likely cause: - Answer-a hard pedal
feel requiring very high pedal effort to stop
- / 2
- | P a g e
A mechanic finds gear lube inside both rear brake drums on a rear wheel drive vehicle. What is the most likely cause of this problem? - Answer-A plugged axle
Which of the following incorrect service procedures will cause brake lock-up? - Answer-master cylinder push rod adjusted too long
Which of the following describes the proper way to depressurized an ABS system? - Answer-Pump the brake pedal at least 25 times (or more, depending on the manufacturer's recommendation) with the ignition off.
The rear brakes are dragging after having new linings installed and the drums machined. the most likely cause is
the: - Answer-technician use the parking brake to adjust
shoes and the cable is stuck
When turning brake drums: - Answer-use a dampening
strap to reduce chatter
Which of the following is NOT a necessary drum brake measurement? - Answer-run-out
- / 2