NACE CIP Level 1 Standards
ASTM D3276
Correct Answer:
Standard Guide for Painting Inspectors. States that the minimum surface temperature for coating is usually 40F, max is 125F.
ISO 8501 St3
Correct Answer:
Very Thorough Hand and Power Tool Cleaning. Same as for St2, but the surface shall be treated much more thoroughly to give a metallic sheen arising from the metallic substrate.
NACE 4 (SSPC-SP7)
Correct Answer:
Brush off Cleaning. Same cleanliness as NACE 1 (SSPC-SP5) and tightly adherent mill scale, rust, and coating may remain on the surface.
SSPC-SP3
Correct Answer:
Power Tool Cleaning 1 / 2
ISO 8501 Sa 2.5
Correct Answer:
Very Thorough Blast Cleaning
NACE 8 (SSPC-SP 14)
Correct Answer:
Industrial Blast Cleaning. Lightly adherent mill scale, rust, and coating residue are permitted to remain on 10% of each unit area of the surface.
NACE 8 (SSPC-SP 14) Lightly adherent mill scale, rust, and coating residue are permitted to remain on ____ of each unit area of the surface.
Correct Answer:
10
SSPC-VIS 3
Correct Answer:
Visual Guide for Rust Grades. Rust Grades A-D (A is the worse)
SSPC SP-1
Correct Answer:
Solvent Pre Cleaning
- / 2