NACE CIP 1 CBT Exam (Quiz & Study Questions)
An advantage of magnetic pull-off DFT banana gauge is that it is ____
Correct Answer:
intrinsically safe
You must take a measurement with a dial-type magnetic pull-off dry film thickness gauge. What is the minimum recommended distance away from an edge that you can reliably take a measurement?
Correct Answer:
2.5 cm (1 inch)
The testing procedure for water soluble ferrous salts is ____
Correct Answer:
potassium ferricyannide test
A well written specification requires a surface profile depth defined as ____
Correct Answer:
a range of measurements 1 / 4
If there is a conflict between the project specification and manufacturer's product data sheet, which do you follow?
Correct Answer:
Follow the specification
What document should be reviewed prior to arriving to a job site to determine if amines or polyamides will be present?
Correct Answer:
Safety Data Sheet (SDS), formerly MSDS
Specification term: Will
Correct Answer:
The owner is responsible for performing the action
Specification term: Should
Correct Answer:
The contractor is strongly recommended but not required to preform the action
Specification term: May
Correct Answer:
The contractor has open choice on actions
- / 4
Specification term: Shall
Correct Answer:
The contractor is required to perform this action
Adding an incorrect solvent to a coating may cause ____
Correct Answer:
non-drying or non-curing
If you find chalking on pre-existing coating, what type of coating would you find suspect?
Correct Answer:
Epoxy
After a cold night, you find that the epoxy amine midcoat applied the day before has blushed. The optimum resolution when amine blush is found is to ____
Correct Answer:
consult the coating manufacturer
The formation of small bowl-shaped depressions in the coating film caused by air trapped in the coating is called ______
Correct Answer:
cratering 3 / 4
Failure of a plural component coating to cure is frequently caused by _____
Correct Answer:
wrong mix ratio
As an inspector on a bridge painting project, prior to abrasive blasting, which blasting safety items would you expect to see?
Correct Answer:
- deadman valve
- connections wired/clipped
- supplied air hood
One of the most common causes of blisters in a coating film is _____
Correct Answer:
surface contamination
You have been inspecting a tank repainting project and suspect that the surface was not cleaned properly, but coating has already been applied, What should you do?
Correct Answer:
consult the owner for guidance
- / 4