NEIEP 700 Final Exam Version 1 Latest Update 2024-2025 Questions and 100% Verified Correct Answers Guaranteed A+ A single phase, full-wave rectifier with 120V AC input will produce how much DC
voltage? - CORRECT ANSWER: 108
A three phase, full-wave power supply uses how many rectifiers? - CORRECT
ANSWER: 6
An elevator equipment room that is equipped with fire sprinklers would require what
type of circuit breaker? - CORRECT ANSWER: Shunt trip circuit breaker
How are latching relays reset? - CORRECT ANSWER: Electrically
How can you reduce contact arcing on plug-in relay contacts? - CORRECT ANSWER:
Wire two contacts of the same relay in series
How must a latching relay be reset? - CORRECT ANSWER: Energize the reset coil
If a car speed were 100 FPM, what should the stopping distance be? - CORRECT
ANSWER: 24 inches
If a relay with the contact arrangement shown in Figure 1 was energized, which
contacts would break? - CORRECT ANSWER: 2 and 8
If a reverse phase relay or overload relay contact were to open, where would the circuit
be interrupted? - CORRECT ANSWER: The CCF fuse and terminal GV
If contact U2 2-3 [1 F2] fails to close when the car runs up, what will happen? -
CORRECT ANSWER: The car will run up in slow speed
If the cam protection timer times out, where will the circuit be opened? - CORRECT
ANSWER: Between 2X and 3X terminals
If the synchronous selector ratio were 40 to 1, and the car moved 20 feet, how far will
the selector have moved? - CORRECT ANSWER: 6 inches
In a properly grounded elevator system, which of the following should be grounded? -
CORRECT ANSWER: Generator Motor Controller All of the above
In the single automatic push button system (SAPB) how many calls can be registered at
one time? - CORRECT ANSWER: One call at a time
- / 1