NEIEP 800 Final Exam

• / 5

NEIEP 800 Final Exam Questions and Verified Answers 100% Guarantee Score Pass

Consist of 100 Questions and Answers

• When welding a joint, lay inch tack welds degrees apart, shift it

90 degrees and lay two more 1 inch tack welds 180 degrees apart.Ans>> 1, 180

• On power units having the motor beneath the tank, the pump may be either

driven or coupled.Ans>> belt, direct

• The purpose of the / is to silence the effect of any pulsations in the

pump output and should be as close to the pump as possible.Ans>> silencer, muffler

• On Bolsters/Bolster Assembly, the plunger is fastened to the

which is then mounted to the center of the Bolster Assembly. 1 / 3

• / 5

Ans>> platen plate

• With wye-delta, reduced current starting is accomplished without the need for .

Ans>> resistors

• run buttons should run the platform and sling at leveling speeds only.

Ans>> Temporary

• A consists of a piston held closed by an adjustable spring and must

open at a certain pressure to prevent any further increase in pressure.-

Ans>> relief valve

8.A lowering valve allows the car to be lowered at a speed not exceed- ing 20fpm in case of power failure.Ans>> manual

• As the oil temperature changes, the will change as well and will

effect the performance, more specifically, the leveling and approach of the elevator.Ans>> viscosity

• Be sure wellways are properly to avoid accidental injury to you, your

team or anyone working outside of our industry.Ans>> barricaded 2 / 3

• / 5

• Barricades around the wellway must be inches high and be capable of

withstanding a lb force.Ans>> 42, 200

12.A protects you if you come in contact with a hot wire or component and then come in contact with ground. It opens the circuit and diverts the supplied current to ground.Ans>> GFCI

• / 3