OSHA 510 Exam Study Guide 253 Questions with Complete Solutions An example of incident Cost would be? - Correct Answers Overtime worked to keep on schedule due to accident Protect the safety and health of America's workers is the mission of what the government agrees - Correct Answers OSHA The General duty clause states that it is the employers responsibility to provide a workspace free from - Correct Answers recognized hazards To ensure consistent enforcement OSHA has set up? - Correct Answers OSHA Directives the right of workers o seek safety and health on the job without fear of punishment is found in? - Correct Answers section (c) of the OSHA ACT OSHA requires that employers __ that abatement is complete for each cited violation. - Correct Answers certify An OSHA inspection begins with - Correct Answers presentation of credentials an employee only able to work a partial work shift due to work-related injury is classified as? - Correct Answers restricted work activity.The number of recordable injuries and illness per 100 full time workers is known as? - Correct Answers incident rate when managers know and follow safety and health rules are demonstrating: - Correct Answers management leadership and commitment to safety and health Safety and Heath program and jobsites inspections by competent person are 2 main components of _____ - Correct Answers An employers accident prevention responsibilities 1 / 3
100 ft is the maximum ___ from any protected point to the nearest fire extinguisher - Correct Answers travel distance _____ signs such as danger and caution shall be visible when work is being performed - Correct Answers Accident prevention A personal fall arrest system shall bring an employee to a complete stop and limit the ___ 3.5 feet. - Correct Answers max deceleration distance Whether paid for by employer or employee, all ____ shall be maintained in a safe condition - Correct Answers Hand and power tools ____ shall be shielded to protect employees and other persons working in the vicinity. - Correct Answers Arc welding and cutting Failure to inspect for _____ on regulation fitting, valves , on the cap thread on a cylinder of oxygen can result in fire - Correct Answers oil and grease PFAS, when stopping a fall, shall be ____ that the employee cannot fall more than 6ft or contact a lower level - Correct Answers rigged such when _____ is/are used perpendicular to a roof edge, the warning lines cannot be closer than ft. - Correct Answers mechanical equipment A ___ deals with the cord-set and receptacles which are not part of the permanent wiring of a building or structure - Correct Answers assured equipment grounding conductor program electrical equipment that operates at 50 volts or higher shall be ___ against accident contact. - Correct Answers Guarded subpart V states that work to be preformed that is __ shall have a job briefing held before the start of day or shift - Correct Answers repetitive or similar Bonding is the practice of connecting two ___ objects to prevent static sparks - Correct Answers metallic 2 / 3
when scaffolding is being erected, moved, dismantled, or altered it shall be ___ by competent person. - Correct Answers Supervised Top rail of a guardrail system must be 42 inches +/- _____ above a walking/ working level - Correct Answers 3 inches a sandy clay loam that has an unconfined compressive strength of 1.2 tsf would be classified as - Correct Answers Class B soil Type A soil can be sloped 1/1:2 ration if the excavation is open less than___ and is less than 12 feet in depth - Correct Answers 24 hours cross bracing on scaffolding is acceptable as a midrail when the cross point is 20-30 inches above the walking surface and - Correct Answers end point are less than 48 inches apart The results of work place injury and illness may include: - Correct Answers lower morale and increase cost to train and replace workers Osha Mission is to - Correct Answers Protect the safety and health of American workers The right of workers to seek safety and health on the job without fear of punishment can be found in? - Correct Answers section (c) of the OSHA ACT when was the OSHA Act sign into law? - Correct Answers 1970 The employers responsibility to provide a workplace free from recognized safety and health hazard is also know as - Correct Answers General Duty Clause Horizontal standards apply: - Correct Answers When a condition is not covered by a specific industry standard Vertical Standards apply: - Correct Answers Only applies to specific industry standards.
- / 3