SHP final Exam Questions with Correct Answers 2024/2025 Rated A+ The firefighter may be installed next to a stand-alone battery smoke detector - Correct Answer True When performing a full system test, you may bypass any open doors or windows - Correct Answer False When programming an skey1,you must - Correct Answer Always enable the emergency When running power to the take345,polarity doesn't apply - Correct Answer False When programming the emergency key for the skey1,which zone/sensor type is used. - Correct Answer Audible alarm (7) When installing a smkt3,you must use the included screws and anchors - Correct Answer True When installing the firefighter, it is required to test the customers existing smoke detectors - Correct Answer True When installing a Dw21, where is the approved location for the sensor - Correct Answer Between 6"(15cm) and 2'(61cm) from floor When installing a dw11 on a vinyl or metal frame, what should primarily use to mount the sensor - Correct Answer Provided double sided tape Which of the following materials can you use to group multiple ground terminals in a takeover. - Correct Answer Beans & wire caps Which of the following sensors are you not allowed to program using a translator - Correct Answer Smoke detector 1 / 2
When installing the take345, you must always test the new 12v battery before using it. - Correct Answer True What is the output voltage of transformer used to power the sky control - Correct Answer 16.5 What is the minimum distance for placement of a co3 from the corners of the wall - Correct Answer 12"
The smkt3 has 2 function:smoke and heat detection - Correct Answer False
How would you program a co3 if mounted on a hallway wall - Correct Answer Loop 1 Zone 14 When installing a translator, you must program all of the existing sensors as new equipment on the panel - Correct Answer False The dw21 should always be installed in the door frame - Correct Answer True Which of the following zone/sensor types are correct when programming an smkt3 - Correct Answer (09) Smoke detector. (09) Heat detector. (08) Freeze What it the correct height ar which to install the Pir2 - Correct Answer 7ft When programming a Dw21 what loop number is used - Correct Answer Loop 2 When programming a sensor into a sky control panel, you can type in the serial number or learn it in by triggering the device. - Correct Answer True How would you program a gb2 when it is mounted on a master bedroom ceiling - Correct Answer Loop 1 Zone 3 Panic pendants are programmed as an audible alarm(type 07) - Correct Answer True
- / 2