Traffic Signal Technician Questions with Correct Answers 100% Verified What is the primary function of IMSA?
- Teaching design issues
- Safety education
- Signal manufacturing training
- Install traffic signals - Correct Answers b
IMSA stands for? - Correct Answers International Municipal Signal Association Which of the following is not an IMS a certification? A traffic signal level to design technician be traffic signal level to field technician see traffic signal level to bench technician D traffic signal level III bridge design technician - Correct Answers D Which of the following are potential safety hazard's? A overhead and underground power be gas see aerial lift equipment D all of the above - Correct Answers D What are the sections of a ramp meter signal? A circular red circular yellow circular green be a circular yellow, circular green sea. Circular read, circular yellow D. Circular read, circular yellow - Correct Answers D
PPE stands for: - Correct Answers Personal protective equipment
Which of the following is an example of adequate fall protection during the operation of aerial lift equipment? A. Full body harness be. Safety belt see. Rails of a platform lift D. All of the above - Correct Answers D A work zone supervisor is responsible for which of the following tasks: a. Maintaining the project schedule B. Ensure advance warning devices have not been removed or relocated see. Enforce traffic laws in the work zone D. All of the above - Correct Answers B Which of the following is not a sentence type in the MUTCUD: a standards be guidance C. objectives D support - Correct Answers C 1 / 2
Which of the following is an example configuration of an emergency vehicle traffic control signal: a two section traffic signal with circular green and circular read indications beer. Three section traffic signal with circular read, circular yellow, and smaller circular yellow indications see. Two section traffic signal with circular green and circular yellow indications D. None of the above - Correct Answers B The following faces are typically assigned to the major street through approaches: - Correct Answers
- and 6
- / 2
The green interval is made up of which three components? - Correct Answers Minimum green, passage time, maximum green What are the three typical types of recall features of a traffic signal controller? - Correct Answers Minimum, maximum, pedestrian Any coordination plan, what is the number of seconds given to each phase at the intersection? - Correct Answers The split Which of the following traffic signal coordination methods is typically the least expensive? - Correct Answers Time-based coordination Which of the following is a definition for cycle length: a. The amount of time given to a particular indication during a particular phase B. The elapsed time between the start of a specific display until that display comes up again see. The amount of time given to the left turning movements of the signalized intersection D. The amount of time given to a single phase of the intersection - Correct Answers B Which of the following is a characteristic of sequential phases: a. They cannot occur at the same time be. They are the phases numbered one to 4C. They are the odd-numbered phases D. None of the above - Correct Answers A Which of the following is a definition for initial green Time: a minimum time that the green indication must be displayed be. Amount of time the green indication as display before a vehicle proceeds into the intersection see. The extended mount of time given to the green indication for each detected vehicle D. None of the above - Correct Answers A The only point in the cycle of a coordinated traffic signal controller were the major street phase is allowed to end is called? - Correct Answers Yield Point