Vivint SHP practice exam 35q
Question: True or false, the fire fighter may be installed next
to a standalone battery powered smoke detector?
CORRECT ANSWER : False
Question: True or false, when performing a full system test
you may bypass any open doors or windows?
CORRECT ANSWER : False
Question: When programming an SKEY1, what must you do?
CORRECT ANSWER : Always enable the emergency key
Question: True or false, when running power to the take-345,
polarity does not matter?
CORRECT ANSWER : False
Question: When programming the emergency key for
SKEY1, which zone/sensor types are recommended to use?
Select all that apply: Audible alarm 07, Auxiliary alarm 08
CORRECT ANSWER : Audible alarm 07, Auxiliary alarm
08
Question: True or false, when installing a SMKT3 you must
use the included screws and anchors?
CORRECT ANSWER : True
Question: True or false, when installing the fire fighter it is
required to test the customers existing smoke detectors?
CORRECT ANSWER : True
Question: When installing a DW 21, where is the approved
location for the sensor?
CORRECT ANSWER : Between 6 inches (15cm) and 2
inches (61cm) from the floor
Question: When installing a DW11 on a vinyl or metal frame,
what should you primarily use to mount the sensor?
CORRECT ANSWER : Provided double-sided tape
Question: Which of the following materials can you use to
group multiple ground terminals in the takeover module?
Select all that apply: B connectors/beans, Wire caps
CORRECT ANSWER : B connectors/beans, Wire caps
Question: Which of the following sensors are not allowed to
program using a translator?
CORRECT ANSWER : Smoke detector
Question: True or false, when installing the take 345 you must
always test the new 12 V battery before using it?
CORRECT ANSWER : True
Question: What is the output voltage of the transformer used
to power the Smart hub?
CORRECT ANSWER : 12 VDC
Question: What is the minimum distance for placement of a
CO3 from the corners on a wall?
CORRECT ANSWER : 12 inches (30 cm)
Question: True or false, the SMK3 has only two functions: smoke and heat detection?
CORRECT ANSWER : False
Question: How would you program a CO3 if mounted on a
hallway wall?
CORRECT ANSWER : Loop 1, zone type 14
Question: When installing a translator, must you program all
the existing sensors as new equipment on the panel?
CORRECT ANSWER : False
Question: When programming a DW 11 that has been
installed on a window, which zone/sensor type should be used?
CORRECT ANSWER : 03
Question: True or false, the DW 21 sensor should always be
installed in the door frame?