Vivint Smart Home Pro Final Exam Questions and 100

Vivint Smart Home Pro Final Exam Questions and 100% Verified Correct Answers 2024 What is the input voltage range of the Doorbell Cam? - Correct Answer 12-24v What is the output voltage of the transformer used to power the SkyControl panel? - Correct Answer 16.5 VAC True or False: When programming a sensor into the sky panel you can type in the serial number or "learn" it in by triggering the device - Correct Answer true When programming a DW21, which loop number is used?1 2

• - Correct Answer 2

Which of the following materials can you use to group multiple ground terminals in a

takeover module:

Solder String Wire Caps Duct Tape Beans - Correct Answer beans and wire caps T or F: When installing the firefighter, it is required to test the customer's existing smoke detectors - Correct Answer True When installing a DW21, what size bit should you use to drill the hole for the sensor?1/2" 3/8" 3/4" 1" - Correct Answer 3/4"

T or F: When installing the TAKE-345, you must ensure that the transformer is

supplying power to the power supply before the battery. - Correct Answer True T or F: You are required to test signals from all secondary keypads and key fobs even though they are not detection devices - Correct Answer True T or F: When running power to the TAKE-345 polarity does not apply - Correct Answer False What is the correct height at which to install the PIR2?

• ft

At least 5 ft At least 7 ft 1 / 2

At 7.5 ft - Correct Answer

• Correct Answer How would you program a CO3 if mounted on a hallway wall?

Loop 1 Zone 8 Loop 1 Zone 14 Loop 3 Zone 4 Loop 1 Zone 4

• Correct Answer When installing a DW21 into a metal door frame, with a wooden door,

what should you be sure to use?Metal Drill bit A DW11 should be used on all metal door frames 3/4" insulated magnet Eye goggles

T or F: Panic Pendants are programmed as an audible alarm - Correct Answer True

• Correct Answer T or F: The Firefighter may be installed next to a stand-alone battery-

powered smoke detector

• Correct Answer Which of the following zone/sensor types are correct when

programming an SMKT3?Type 9 - Freeze Detect Type 7 - Freeze Detect Type 9 - Heat detect Type 6 - heat detect type 1 - heat detect type 8 - freeze detect type 5 - smoke detect type 7 - smoke detect type 9 - smoke detect

• Correct Answer When installing a DW21 where is the approved location for the

sensor?Anywhere in the door between 6"(15 cm) and 2' (61 cm) from floor Below 6" from the floor Top of the door

• Correct Answer T or F: When performing a full system test, you may bypass any open

doors or windows

• Correct Answer T or F: When installing a translator, you must program all of the

existing sensors as new equipment on the panel

• / 2